Browse by author
Lookup NU author(s): Natacha Rodrigues, Dr Matthew Benning, Dr Ana Ferreira-DuarteORCiD, Dr Luke Dixon, Professor Kenneth Dalgarno
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License (CC BY-NC-ND).
Bone scaffolds must have an appropriate porosity range with an interconnected and open porosity, and have a biodegradable rate and mechanical properties that match the injured tissue. The use of commercially available and low cost 3D printing machines offers the ability to fulfil these requirements. Therefore, one of the aims of this study was to manufacture a PLA scaffold by a two-step route: 1) 3D printing of a PLA porous bar and 2) laser cut PLA scaffolds from the 3D printed bar. Laser cutting did not cause any significant degradation issues and scanning electron microscopy showed that 3-D scaffolds had completely interconnected and uniform open porosity, with pore size between ∼550 to 600 μm in both axial and transversal direction. Conversely, mechanical test of PLA scaffold indicated that both compressive modulus and stress at yield were decreased by the laser cutting step but they remained adequate for trabecular bone replacement. Finally, the in vitro degradation behaviour of PLA scaffolds after 8 weeks immersed in PBS, did not revealed any significant decrease of weight, molecular weight, and compressive properties.
Author(s): Rodrigues N, Benning M, Ferreira AM, Dixon L, Dalgarno K
Publication type: Conference Proceedings (inc. Abstract)
Publication status: Published
Conference Name: The Second CIRP Conference on Biomanufacturing
Year of Conference: 2016
Pages: 33–38
Online publication date: 28/07/2016
Acceptance date: 17/07/2015
Date deposited: 26/08/2016
ISSN: 2212-8271
Publisher: Elsevier BV
URL: http://dx.doi.org/10.1016/j.procir.2015.07.025
DOI: 10.1016/j.procir.2015.07.025
Data Access Statement: http://dx.doi.org/10.17634/122951-1
Series Title: Procedia CIRP
